Refrigeration · 5 min

Cold room defrost faults, explained

Ice on the ceiling, a door that freezes shut and a rising room temperature all trace back to the defrost cycle.

01

How a defrost cycle should work

A cold room builds frost on its evaporator as it runs. At intervals heaters warm the coil until the frost melts, a termination sensor confirms the coil is clear, and refrigeration restarts. Every step depends on the one before it.

When a heater fails the coil never clears and airflow collapses. When the termination sensor drifts the cycle ends too early or runs far too long. When the drain freezes, meltwater has nowhere to go and refreezes at the base of the coil.

02

Reading the symptoms

Ice on the ceiling above the evaporator suggests a fan running during defrost, throwing moisture upward. Ice around the door frame usually means a failed door heater or a hardened gasket letting humid air in. A room that pulls down slowly after restocking often has a partly blocked coil rather than a failing compressor.

Water on the floor is the drain almost every time: a frozen line, a blocked trap, or a line run with the wrong fall.

03

What a proper repair involves

Test the heater, the termination sensor and the controller against the actual room, replace what has failed, then verify a full defrost cycle with the room loaded the way your kitchen loads it.

Defrost parameters set for an empty room behave differently on a Friday afternoon with warm stock going in. Commissioning should happen under real conditions.

Tokai · TK-LEAD

Need this looked at properly?

Send the details and we will tell you what is involved, what it is likely to need and when we can attend. Urgent refrigeration failures: call directly.

Call WhatsAppEnquire