Service FR-05 · Refrigeration

Freezer room installation and repairs

TOKAI TERRITORY · FR-05

Freezer room design, installation and repair, with defrost, door heater and drain work that survives a working kitchen.

A freezer room runs at a lower evaporating temperature than a cold room, which changes every part of the specification.

Freezer rooms are specified differently from chillers: thicker panels, a low-temperature evaporator, heater wires in the door frame and drain, and a defrost cycle that has to complete reliably at -18 degrees or below. We install and repair rooms for butchers, bakeries, caterers and food producers, including conversions of existing storage rooms.

Most freezer room failures trace back to defrost and drainage. A heater fails, a termination sensor drifts, or meltwater refreezes at the base of the coil until airflow collapses. Fixing the symptom without verifying a full defrost cycle just moves the next breakdown a few weeks out.

Symptoms we attend

  • Heavy frost on the evaporator that never clears
  • Room temperature rising above -18 degrees
  • Door freezing shut or failing to seal
  • Ice on the floor at the door and drain
  • Compressor running continuously
  • Water pooling outside the room

Scope of work

What we actually do

Scope confirmed on site before any work begins, with the equipment and access constraints of the building taken into account.

  • New freezer room installation and panel upgrades
  • Low-temperature evaporator and pack replacement
  • Defrost heaters, termination sensors and controllers
  • Door heater wire and gasket replacement
  • Drain line heating, trapping and re-routing
  • Full defrost cycle verification under load

This service by suburb

Technical questions

Can an existing cold room be converted into a freezer room?

Sometimes. It depends on panel thickness, the evaporator, the door and the drain. We assess the envelope first, because a room built for chilling will usually need more than a thermostat change.

How often should a freezer room defrost?

It depends on how much warm product and humid air enters each day. We set and verify the cycle against your actual loading rather than a factory default.

Why is there ice on the floor by the door?

Almost always a blocked, unheated or badly trapped drain, sometimes combined with a door heater that has failed. Left alone it becomes a safety and panel-damage problem.

Related services

Tokai · TK-LEAD

Need freezer room installation and repairs?

Send the details and we will tell you what is involved, what it is likely to need and when we can attend. Urgent refrigeration failures: call directly.

Call WhatsAppEnquire